more wires
I installed the wiring harness for the AoA indicator and control computer. I seem to enjoy the installation of the little micro connectors. I terminated the wires for the flap switch and tested it. It is just too much fun to watch the flap weldament go up and down to pass up :). I wired up all of the autopilot servo and control wires except for the ARINC and RS232 inputs from the GPS. I ditched the solder on 25 pin connector and went with d-sub crimp connectors instead. Almost all of the antenna wires are run (not terminated). Obviously, I’m not doing wing root disconnects. Oh, yeah, I also finished up terminating the wires at the strobe power supply.
