Finalizing wiring runs
I’ve been working diligently to clean up and finalize all of my wiring bundles. I’ve been wrapping some stuff with silicone tape, replacing temporary (oversized) adel clamps with the final correctly sized clamps with final bolt attachment (not fun at all). I’ve been resolving minor routing conflicts, etc., etc.. All very small, very time consuming details to get from the wiring “process” to the flying state. I’m also taking a small step back to fabricate brackets to secure the rear of the radio stack to the sub panel. This is a bit of a trick since the screw holes in the trays land dead center of the sub panel, so the angle to put the screws through for attachment has to be secured with spacers away from the sub panel.
I also got the nylon screws that secure the magnetometer installed.
