More Ignition wires
Ignition wire installation is done, minus a few adel clamps.
Last session before I closed shop, I put the plenum top on and heated up the glass layup that I had previously done on the outboard inlet ears in order to clamp and shape them perfectly. I took a few more pictures of the plenum top before I pulled it back off since I’ve been getting more questions about it.
Time to get back to work on the ignition wires. I include a picture sequence of the installation of the coil end for amusement. All of the white tie-wraps are temporary. Later I went back and final tied the ignition wires. I even tinkered with using wax wire lacing instead of plastic tie-wraps. That worked quite well, so I used the lacing cord in the locations that were reasonably accessible.
I also got the oil cooler hose fittings torqued and final installed.
